CH C1 - Factory Setting

4.3.1.4 FACTORY SETTING
The C1 SETUP >> FACTORY SETTING menu allows to get information about
current C1 firmware version, to update the C1 firmware, to reset the unit to
default configuration (or subset of setting), and to calibrate the DAC stage.
Accessible Parameters are:
- FIRMWARE VERSION:
- UPDATE FIRMWARE:
- RESET ALL SETTING:
- SERIAL NUMBER:
- SHORTCUTS:
- INPUT ENABLED:
- INPUT GAIN:
- INPUT NAMES:
- REMOTE CONTROL:
- CALIBRATE:
- NETWORK:
Current firmware version (read only)
Allows to update the unit's firmware
Returns the unit to factory settings
Displays the serial number of the machine
Redefines all Shortcuts to factory settings
Allows to enable all digital inputs at once
Reset all input gain to 0 dB
Put back default name to all inputs
Select to which set of RC5 commands the C1 responds
Run auto-calibration process
Clears list of detected devices on network
The following table details the Parameters of the FACTORY SETTING menu:
PARAMETER RELATED ACTION/VALUE REQUIRED OPTIONS REMARKS
FIRMWARE VERSION Firmware version None Firmware version indicates the version of the
current firmware. Format is x.y. This parameter is
read only.
UPDATE FIRMWARE Update None Selecting 'Update' launches the C1 firmware update
process. A USB flash disc drive with a valid set of
firmware must be inserted in the A-shaped USB port
RESET ALL SETTING Reset None Selecting 'Reset' returns the C1 to its factory
settings. Factory settings are detailed in the
Specifications section.
SERIAL NUMBER Serial number None Serial number indicates the serial number of the C1.
Format is yymm02nn. This parameter is read only.
SHORTCUTS Default mapping None Selecting 'Default Mapping' returns the C1's
Shortcuts to their factory settings. Factory settings
are detailed in the Specifications section.
INPUT ENABLE Enable all None Selecting 'Enable all' will enable all available
C1inputs.
INPUT GAIN Set default gain None Set back the gain/attenuation of all inputs to 0dB.
INPUT NAMES Default names None Set back all input names to their default value
REMOTE CONTROL None
RC5 Pre1
RC5 Pre2
None Selects to which set of RC5 commands the C1 will
respond to. Pre1 is the standard RC5 Preamplifier
set, Pre2 is an alternate RC5 Preamplifier set (it
corresponds to the set of commands the C1 remote
Rev 1.9 C1 User Manual 41