3.3 Connections
This section provides information about how to connect your C1 D/A controller to your system. As the C1 is a modular design with
different optional boards, the description applies to the example configuration presented below. If your options do not match the
example or you don't feel secure with the connections to be applied to your configuration, please contact your authorized dealer
for assistance.
The example configuration is a full featured controller with many inputs (standard digital input AES-EBU, Coaxial and Optical, CH-
Link, USB and balanced and single-ended analog in) and clock synchronization option (SYNC_IO board). This is one of the most
complete configurations of C1. If your configuration does not include some of the presented options, just discard the corresponding
connections.
Rear panel connections
(1) 75 Ohm RCA single-ended analog output for right channel
(2) 50 Ohm BNC single-ended analog output for right channel
(3) 75 Ohm RCA single-ended analog output for left channel
(4) 50 Ohm BNC single-ended analog output for left channel
(5) BNC clock input. Provides 75Ohm or Hi-Z input. [optional SNYC_IO board]
(6) Ethernet port for command interface [CONTROL board] or for audio streaming and commands [optional NETWORK board]
(7) TOSLINK (S/PDIF) digital input [DIGITAL_IN #1 board]
(8) AES-EBU digital input [DIGITAL_IN #1 board]
(9) USB audio [optional USB_IN board]
(10) RCA single-ended analog input for left channel [optional ANALOG_IN board]
(11) XLR balanced analog input for left channel [optional ANALOG_IN board]
(12) Earth connector. Internally connected to digital ground
(13) External power supply connector for X1 power supply option
(14) Power on/off switch
(15) XLR balanced analog output for right channel
(16) XLR balanced analog output for left channel
(17) BNC 75 Ohm clock output 2. [optional SYNC_IO board]
(18) BNC 75 Ohm clock output 1. [optional SYNC_IO board]
Rev 1.9 C1 User Manual 19
To Next Page
Loading...