• C/Sub channels C1 clock source (for this input): SYNCHRO BNC 75 Ohm
4.5.5 C1 D/A controller + Computer (USB audio)
When a C1 equipped with a USB_IN board is used together with a computer for audio files playback, a single link is in place
between them: a type A (computer side) to type B (C1 side) USB 2.0 cable. But this single link enabled data to flow from the
computer to the C1, while the C1 give the pace of the data transfer, thus being clock master. Schematic below shows how to connect
such system:
USB Computer to C1 connection
In such case:
• C1 clock source (for this input): INTERNAL
4.5.6 C1 D/A controller + Computer (Ethernet audio streaming)
When a C1 equipped with a NETWORK streaming board is used together with a computer for audio files playback, a single link is in
place between them: an RJ45 Ethernet cable. But this single link enabled data to flow from the computer to the C1, while the C1
give the pace of the data transfer, thus being clock master. Schematic below shows how to connect such system:
Rev 1.9 C1 User Manual 49
Computer with USB port (e.g. Laptop)
C1 D/A Controller, 1x DIGITAL_IN + 1x USB_IN
U
S
B
A
-
B
c
a
b
l
e
A
u
d
i
o
C
l
o
c
k