29
Your garage door opener is equipped with features to provide you with greater control over your
garage door operation.
TIMER-TO-CLOSE
The Timer-to-Close feature automatically closesthe door after a specified time period that can be
adjusted using a TTCenabled door control. Prior to the door closing there will be an audible and visual
alert.
MyQ™
MyQ™ technologyuses a 900MHz signal to provide two-way communication between the garage door
opener and MyQ™ accessories.Your garage door opener is compatible with up to 16 MyQ™
accessories.
SECURITY+
®
2.0 REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener is compatible with up to 2 SmartControl Panels or 4 ofany other
Security+
®
2.0 door controls. Your garage door opener has already been programmed atthe factoryto
operate with your remote control, which changes with each use,randomly accessing over 100 billion
new codes. The garage door opener is compatible with up to 24 remote controls.
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properlyconnected and aligned, the safety reversing sensors will detect an obstruction in the
path of the infrared beam.If an obstruction breaks the infrared beam while the door is closing, the door
will stop and reverse to full open position, and the opener lights will flash 10 times. If the door is fully
open,and the safety reversing sensors are not installed, or are misaligned, the door will not close from
a remote control. However, you can close the door if you hold the button on the door control or keyless
entry until the door is fully closed.The safety reversing sensors do no effectthe opening cycle.
ENERGY CONSERVATION
For energy efficiencythe garage door opener will enter sleep mode when the door is fully closed. The
sleep mode shuts the garage door opener down until activated.The sleep mode is sequenced with the
garage door opener lightbulb;as the lightbulb turnsoff the sensor LEDs will turn off and whenever the
garage door opener lights turn on the sensor LEDs will light. The garage door opener will notgo into
the sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener lightbulbswill turn on when the opener isinitially plugged in; power is
restored after interruption, or when the garage door opener is activated.The lights will turn off
automatically after 4-1/2 minutes.An incandescent A19 lightbulb (100 watt maximum) or for maximum
energy efficiency a 26W (100W equivalent) compact fluorescent light (CFL) bulb maybe used.
LIGHTS FEATURE
The garage door opener is equipped with an added feature; the lights will turn on when someone
enters through the open garage door and the safety reversing sensor infrared beamis broken.For
added control over the light bulbson your garage door opener, see the Door Control section.
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted door control, remote control,
wirelesskeyless entryor MyQ™ accessory.
When the door is closed and the garage door opener is activated the door will open.If the door senses
an obstruction or is interrupted while opening the door will stop. When the door is in anyposition other
than closed and the garage door opener is activated the door will close. Ifthe garage door opener
senses an obstruction while closing, the door will reverse.If the obstruction interruptsthe sensor beam
the garage door opener lightswill blink 10 times. However, you can close the door if you hold the button
on the door control or keyless entryuntil the door is fully closed.The safety reversing sensors do no
effectthe opening cycle.
The safety reversing sensor mustbe connected and aligned correctlybefore the garage door opener
will move in the down direction.
Features
To Next Page
Loading...
