Chamberlain CSW200UL - Factory Installed DC2000 Connection; DC2000 Startup

21
CLASS I, II, III, IV
Socket
FACTORY INSTALLED DC2000™ CONNECTION
DC2000™ 12Vdc Radio Receiver (Not Provided)

+12
Jumper P2:

Jumper P3:

NOTE: Refer to page 29
and 30 for programming
radio receiver.
DC2000™ Startup

System ONCharge OKBattery Low


Gate Direction

Reverse Sensor

Hold

Hold

110Vac Power Failure
110Vac Power On,
OmniControl™ Board Malfunction
Auto Mode
Manual Mode
NOTE: All devices wired to the DC2000™ MUST be dedicated to it alone. Normal operation will be controlled by separate devices wired
to the OmniControl™ board and surge suppressor.
Example:
One-ButtonThree Push ButtonKey SwitchPhotoelectric SensorEdge Sensor
