Chamberlain LA350 - LiftMaster Internet Gateway Programming; Erase LiftMaster Internet Gateway

19
PROGRAMMING
LiftMaster
®
Internet Gateway
To program the operator to the LiftMaster
®
Internet Gateway:
1. Connect the Ethernet cable to the LiftMaster
®
Internet Gateway and the router.
2. Connect power to the LiftMaster
®
Internet Gateway.
3. Create an online account by visiting www.myliftmaster.com.
4. Register the LiftMaster
®
Internet Gateway.
5. Use an internet enabled computer or smartphone to add devices. The LiftMaster
®
Internet Gateway
will stay in learn mode for three minutes.
6. Press the LEARN button on the operator (LED1 will light as it enters learn mode). The LiftMaster
®
Internet Gateway will pair to the operator if it is within range and LED1 will fl ash and go out if
programming is successful.
Erase a LiftMaster
®
Internet Gateway
1. Press and hold the LEARN button , LED1 will light.
2. Hold the LEARN button for approximately 6 seconds. LED1 will go out and all remote control codes
are now erased.
3. Press and hold the LEARN button a second time, LED1 will light again.
4. Hold the LEARN button for approximately 6 seconds. LED1 will go out and all gateways are now
erased.
LEARN