EasyManua.ls Logo

Chamberlain MT5011U - Safety Information; General Safety Warnings; Cautionary Notes; Important Operational Notes

Chamberlain MT5011U
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
TABLE OF CONTENTS
SAFETY INFORMATION 2-3
APPLICATION 3
OPERATOR SPECIFICATIONS 4
CARTON INVENTORY 5
PREPARATION 5
ASSEMBLY 6-8
TYPICAL INSTALLATION 9-14
Install the Header Bracket . . . . . . . . . . . . . . . . . . . 9
Install the Operator . . . . . . . . . . . . . . . . . . . . 10-11
Power Ground Wiring Connections . . . . . . . . . . . . 11-12
Install 3-Button Control Station . . . . . . . . . . . . . . 12-13
Setup Radio Antenna . . . . . . . . . . . . . . . . . . . 13-14
ADJUSTMENT 15
Adjust the Limits. . . . . . . . . . . . . . . . . . . . . . . .15
Adjust the Clutch. . . . . . . . . . . . . . . . . . . . . . . .15
ENTRAPMENT PROTECTION 16-19
LiftMaster Monitored Entrapment Protection (LMEP) . . . . .16
Install the Photoelectric Sensors. . . . . . . . . . . . . . . .17
Mount the Photoelectric Sensors . . . . . . . . . . . . . . .18
Entrapment Protection Wiring Options . . . . . . . . . . 18-19
LOGIC BOARD LAYOUT 19
BASIC PROGRAMMING 20-23
Determine the Wiring Type . . . . . . . . . . . . . . . . 20-21
Remote Controls. . . . . . . . . . . . . . . . . . . . . . 21-22
Timer-to-Close (TTC) . . . . . . . . . . . . . . . . . . . 22-23
TESTING 23
EMERGENCY DISCONNECT 24
TROUBLESHOOTING 25-26
DIAGRAM 26
ACCESSORIES 27
CONTROL CONNECTION DIAGRAM BACK COVER
SAFETY INFORMATION
Mechanical
Electrical
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING
WARNING
CAUTION
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA ADVERTENCIA
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING
CAUTION
WARNING
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA ADVERTENCIA
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING
CAUTION
CAUTION
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA ADVERTENCIA
IMPORTANT NOTES:
BEFORE attempting to install, operate or maintain the operator,
you must read and fully understand this manual and follow all
safety instructions.
DO NOT attempt repair or service of your commercial door and
gate operator unless you are an Authorized Service Technician.
When you see these Safety Symbols and Signal Words on the
following pages, they will alert you to the possibility of serious
injury or death if you do not comply with the warnings that
accompany them. The hazard may come from something
mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will
alert you to the possibility of damage to your door and/or the door
operator if you do not comply with the cautionary statements that
accompany it. Read them carefully.

Related product manuals