37
DETERMINE AND SET WIRING TYPE (CONTINUED)
IMPORTANT NOTES:
1. External interlocks may be used with all functional modes.
2. Auxiliary devices are any devices that have only dry contacts. Examples: loop detector, pneumatic or electrical treadles, radio controls,
one button stations, pull cords, etc.
3. Open override means that the door may be reversed while closing by activating an opening device without the need to use the stop
button fi rst.
4. When the door is in a stopped position other than fully closed, and an LMEP or EDGE input is activated, the Restricted Close (RC)
feature will allow a close command when the close button is pressed and held. The operator will begin closing after 5 seconds. If the
close button is released the door will stop.
When in E2 mode, the door will move to the fully open position.
Programming
To Next Page
Loading...
Need help?
General
