Champion Compressors Pty. Ltd. Manual No. 975425 Rev. C
51
8.3.3 Every 6,000 Hours (Or Yearly)
Perform all checks listed for Every 1,500 hours as well as the following:
• Replace the separator element.
• Replace the purge line filter (when separator element replaced).
• Replace the vee belts ensuring the correct tension adjustment
procedure is followed (refer Section 8.8 - Belt Tension Adjustment).
• Check the condition of the compressor oil if it has not been changed
due to the lack of hours run.
• Check the condition of the inlet control valve and service if necessary.
• Check the condition of the minimum pressure valve and service if
necessary.
• Check the condition of the thermovalve and service if necessary.
• Check all nuts, bolts, pipe fittings and electrical connections are tight.
• Check the operation of all safety devices.
8.3.4 Every 8,000 Hours
• Change synthetic oil (Sullube)
Note: Service intervals may be extended if the compressor is installed in a
clean, cool environment. Refer to Champion Compressors Customer Care
Division for advice on the correct service interval for your installation.