28 | UTM-1 Getting Started Guide
Install a Policy Package
To install a Policy Package:
1. Create a policy using the security rule base.
2. Click Policy > Install from the menu.
3. Choose the installation components:
a) Installation Targets — the Security Gateways on which the policy is installed.
By default, all gateways that are managed by the Security Management server are
available for selection. Alternatively, define specific gateways per Policy Package
through the Select Installation Targets window (accessed by clicking Select Targets).
b) For each installation target, choose the policy components (Advanced Security, QoS
or Desktop Security) to be installed.
c) The installation Mode — what to do if the installation is not successful for all targets (so
different targets enforce different policies):
Install on each gateway independently, or
Install on all gateway, or on none of the gateways.
4. Click OK.
The Installation Process window is displayed, allowing you to monitor the progress of the
verification, compilation and installation.
If the verification is completed with no errors and the Security Management server is able to
connect to the gateway securely, the Policy installation succeeds.
If there are verification or installation errors, the installation fails (in which case you can
view the errors to find the source of the problem).
If there are verification warnings, the installation succeeds with the exception of the
component specified in the warning.
Advanced Configuration
Advanced configuration on Gaia
Advanced configuration on Gaia can be done using the WebUI or the CLI.
Advanced configuration on SecurePlatform
Advanced configuration on SecurePlatform can be done using the sysconfig menu from the
CLI.
Note - The sysconfig menu is only available after running
the First Time Configuration Wizard in the WebUI.
To Next Page
Loading...
