CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Oil changing
isassembly procedure:
Lift the vehicle
Place an oil box under the transmission to collect the oil.
Loosen the oil drain plug to drain the oil inside the transmission.
Loosen the oil pan’s connecting bolt and take off the oil pan and gasket.
Inspect if the oil pan’s flanged edge is twisted or deformed. If yes, align it.
clean oil pan, oil pan gasket and oil feed filter screen. Replace a new one if
and oil feed filter screen.
1. ew gaskets.
Tighten the oil pan’s connecting bolt.
rque:15Nm
Lower the vehicle.
Fill in correct transmission hydraulic fluid.
Check the fluid level
Check if the oil pan leaks.
il feed filter screen and gasket
isassembly procedure:
Lift the vehicle
Remove the oil pan and gasket.
Remove the oil feed filter screen’s back cover, oil feed filter screen and gasket.
powder, cermet powder from the clutch’s surface, rubble
parti matters from the engine coolant on the oil filter screen and oil pan. If yes,
nd out the reason and make necessary repair.
Please refer to “Position P—No power”, “Position R-no back gear”, “shift noise at the higher
eed”, “slow gearshift” and “oil pump suction noise” and other chapters for detailed analysis.
ssembly procedure:
Install new gasket, oil feed filter screen and filter screen back cover.
en back cover’s fixing bolt
Install oil pan gasket and oil pan
Lower the vehicle
Check the fluid level
D
1.
2.
3.
4.
5.
6. Use the detergent to
the used gasket has any damage.
7. Blow dry the oil pan, oil pan gasket
Assembly procedure:
Install the oil pan with n
2.
To
3.
4.
5.
6.
O
D
1.
2.
3.
Inspection procedure:
Check whether there are metal
cles, and foreign
fi
sp
A
1.
2. Install the filter scre
Torque: 8Nm
3.
4.
5.
41
To Next Page
Loading...
