specified method.
k can be felt).
15.ECU Programming
New ECU should be programmed when replacing HECU or ECU. Otherwise ABS warning light will flash and
rogramme ECU using scan tool by following methods:
and 15+3Nm(M12×１).
* Fill new brake fluid to fluid reservoir until fluid level reaches MAX, and bleeding as
* Turn ignition to ON position, ABS warning light should go on 1.7 second and then off.
* Clear fault code memory, and retrive again. Ensure no codes in memory.
* Finally perform vehicle drive test to confirm ABS function correctly (pedal kic
system doe not operate.
P
Connect scan tool to diagnostic socket
Enter 03 at press Q key. ADDRESS,
Enter 07 at FUNCTION SELECT, press Q key.
Enter approciate code 01901 (see ABS electrical circuit) at CODE INPUT.
Display code being entered, press
Enter 06 at FUNCTION SELECT, press Q key. END
Chery SQR7160 series sedan ABS system－fault diagnostic and repairing
29
To Next Page
Loading...
