Chery A11 2003 - Operating Method; Scan Tool Operating Method and Function Introduction

3. Scan Tool, Operating Method and Function Introduction
3.1 Operating Method
* Ignition off, connect scan tool to diagnostic connector, then turn ignition on.
* Enter 03, then press Q key，ABS will be in operation condition.
* Enter the function code.
* Enter 06, then press Q key，exiting。
* After power off, remove scan tool.
3.2 Function Introduction
* Function 01—condition information display
* Function 02—fault inquiry
* Function 03—hydraulic controlled unit diagnostic
* Function 04—filling fluid and bleeding
* Function 05—clearing fault codes memory
* Function 06—end，exit.
* Function 07—controller programme
* Function 08—measured data display (such as wheel speed signal etc.)
3.3 Key
* Key C — Cancel, change input data and current menu
* Key Q — Confirm entering
* Key → — Next
* Key HELP — Help Information
3
Chery SQR7160 series sedan ABS system－fault diagnostic and repairing