CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
2.Plu
83
g in the carrier rod of
brake band C’. Install the
adjusting bolt, washer and
adjusting nut. The
adjusting bolt is screwed in
by half.
ote: Two disk washers have
assembled so that the sunk
de faces each other.
br
3
e
der.
Put a new O-ring on piston
C’. Then put piston C’ on the
piston push rod and fix it
N
be
si
Otherwise, it will influence the
ake’s working.
.Put the two disk washers on
the piston’s push rod. The
thicker one is close to th
shaft shoul
4.
with a snap ring.
To Next Page
