Chery A11 2003 - Page 537

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
4. Install clutch E assembly and
snap ring;
the
e clutch E assembly on
utput shaft and 1
st
gear
ne-way overrun clutch
KA
KA emover
isassem
Remove the automatic
transmission assembly from the
vehicle:
Remove the output shaft and 1
st
gear one-way overrun clutch
from the automatic transmission;
Remove the snap ring on the
output shaft;
Separate the output shaft from the
gear ring;
5. Put the adjusting washer on
input shaft:
6. Install th
the transmission:
7.Install the assembled transmission
assembly on the vehicle.
O
o
Special tool:
KA-000-060 bearing remover
-000-232 bearing remover
-000-300 bearing r
bly procedure: D
1.
2.
3.
4.
105