Parameters of Capacity and Specifications
Initially raise the vehicle
Inspect the wheel hub bearing for abnormal noise
Inspect the pressure and appearance of tyres
Change the positions of tyres
Inspect the pressure and appearance of spare tyre
Drain the old engine oil and install back the oil block
Replace the engine oil filter with new one and clean the bottom of engine
Replace the gear oil of gearbox with new one and clean the gearbox
Replace the petrol filter with new one
Inspect the torque of chassis bolt
Inspect the rear axle and the fuel tank
Inspect the relevant pipelines of chassis for oil leakage
Inspect the transmission shaft and the steering tie rod
Inspect the protective sleeve of transmission shaft universal joint for breakage
Inspect the protective sleeve of steering cross tie rod universal joint assembly for breakage
To Next Page
