Chery SQR372 - Removal of Camshaft Cover Cap and Camshaft Bearing Cover

SQR7080 Service Manual 372 Engine Mechanical System
Chery Automobile Co., Ltd
13
Exhaust
Intake
4 Removal of camshaft cover cap and camshaft
bearing cover
(1) Align the marks on the camshaft gears as shown in
the right figure.
Set bolt
（2）Use bolt to position the master and slave gears on
the air inlet camshaft, as shown in the right figure.
Attention In order to eliminate the radial force, keep the
camshaft in the leveled position before dismounting it
(to avoid possible damages caused by excessive radial
forces)
（3）Remove the bolts in the sequence shown in the
right figure;
Remove the camshaft bearing cover
SST
（4）Remove the spark plug
（5）Remove the camshaft slave gear. Use the special
tool as shown in the right figure.
Clip the camshaft tightly, and turn the gear, to keep
the bite state of master and slave gear; remove the fixing
bolts of slave gear.
Attention Do not damage the surface of the camshaft.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.com.cn