SQR7080 Service Manual 372 Engine Mechanical System
Chery Automobile Co., Ltd
4. Installation
4.1 Installation of crankshaft timing gear
4.2 Installation of timing belt
4.2.1 On the upper thrust point of the first cylinder
compression
Place the camshaft timing gear around the front end of
the air exhaust camshaft so as to make the positioning
groove on the gear be aligned with the positioning pin
on the end surface of the camshaft. Then use screws to
fix the clockwise gear, with the torque of 100 ± 5N.m.
4.2.2 Make sure that the punched mark on the
crankshaft clockwise pulley is aligned with the mark
of the oil pump.
4.2.3 Install timing pulley accordingly.
Timing mark
Timing mark
Clockwise
Timing mark
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.com.cn
To Next Page
Loading...
