SQR7080 Service Manual 372 Engine Mechanical System
Chery Automobile Co., Ltd
3-5 Installation
① Fix the two φ6 holes of the camshaft gear S/A.
② Turn the slave gear to the right, match the mark hole
on the slave gear with the mark on the master gear, or
align the marks on the slave gear with the mark on the
master gear; then fix the slave gear with bolt.
(thread: M5; pitch: 0.8)
SST
2、Installation of the camshaft
Attention Size of the axial clearance of the camshaft
(1)、Smear lubricating oil at the camshaft gear section
and the cylinder cover axial diameter section.
(2)、Fix the camshaft slave gear by roughly adjusting on
the cylinder cover.
(3) It is necessary to measure the size of axial clearing
of camshaft.
Exhaust
（4）Install camshaft, the timing mark must be aligned
shown as the right figure.
（5）Smear lubricating oil on the camshaft assembly, the
gears and the cylinder head axial diameter section.
3 Tighten the camshaft bearing cap shown as right
figure.
4 Remove the bolt for fixing the slave gear of the
camshaft assembly.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 ÿ www.fineprint.com.cn
To Next Page
