Driving and Operating 9-51
End Charge
1. Unlock the vehicle with the RKE
transmitter to disarm the charge
cord theft alert.
2. Unplug the vehicle plug of the
charge cord from the vehicle by
squeezing the vehicle plug lever
and pull to remove.
3. Close the charge port door by
pressing firmly in the center to
latch properly.
4. Unplug the charge cord from the
electrical outlet.
5. Before storing the charge cord,
have the charge cord face up
and wrap the charge cable
neatly counterclockwise around
the body of the charge cord.
6. Place the charge cord,
face down, into the storage
compartment with the front
edge (F) of the charge cord
body under the clips (G) located
in the front of the storage
compartment. The vehicle
plug (B) should be on the
right side of the charge cord.
7. Push the charge cord handle
down until it locks into the
handle clip at the rear of
the storage compartment.
While the charge cord is plugged
into the vehicle, the vehicle cannot
be driven.
To Next Page
