Keys, Doors and Windows 2-5
3. Remove the rubber mat in
the instrument panel storage.
Extend the key blade on the new
transmitter and insert the key
blade into the transmitter slot.
4. Press and hold the POWER
O
button on the center stack
for two seconds. When the
transmitter is programmed, the
DIC will show that it is ready to
program the next transmitter.
5. Remove the transmitter from the
transmitter slot and press
K on
the transmitter.
To program additional
transmitters, repeat Steps 3
through 5.
When all additional transmitters
are programmed, press and
hold the POWER
O button
for 10 seconds to exit
programming mode.
Programming without a
Recognized Transmitter
Non-Canadian (U.S.) owners
are permitted to program a
new transmitter to their vehicle
when a recognized transmitter
is not available. The Canadian
regulations require that Canadian
owners see their dealer for
programming new transmitters
when two recognized transmitters
are not available. If there are no
currently recognized transmitters
available, follow this procedure to
program up to five transmitters.
To Next Page
Loading...
