Keys, Doors and Windows 2-9
With the remote start feature, the
RKE transmitter functions will have
an increased range of operation.
However, the range may be less
while the vehicle is running.
Other conditions can affect the
performance of the transmitter.
See Remote Keyless Entry (RKE)
System on page 2‑3 for additional
information.
Activating the Remote Start
To heat or cool the passenger
compartment using remote start:
1. Aim the RKE transmitter at the
vehicle.
2. Press
Q on the RKE transmitter;
the doors will lock.
3. Within five seconds press and
hold
B until the turn signal
lamps flash or for approximately
four seconds. Pressing
B again
during a remote start will turn the
feature off.
Remote start will automatically shut
off after 10 minutes unless a time
extension is done.
While the remote start is active,
the parking lamps will turn on and
remain on.
After entering the vehicle during a
remote start, press the POWER
O
button on the center stack with the
brake pedal applied to operate as
normal.
The remote start can be initiated
two separate times between
driving. For each remote start, the
passenger compartment will be
heated or cooled for 10 minutes.
Extending the Time
To extend the time of the first
remote start, repeat the steps for
activating remote start. Remote
start can only be extended one
time between driving.
Canceling Remote Start
To cancel a remote start, do any of
the following:
.
Aim the RKE transmitter at the
vehicle and press and hold
B
until the parking lamps turn off.
.
Turn on the hazard warning
flashers.
.
Press the POWER O button on
the center stack, with the brake
pedal applied, then press the
POWER
O button again to turn
the vehicle off.
To Next Page
Loading...
