EasyManuals Logo

Chore-Time FLEX-AUGER 108 Installation Manual

Default Icon
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Model 108 FLEX-AUGERļ›š Installation Manual
( 54 )
7. If the system must be disassembled, extreme caution must be
used to prevent injury from springing auger.
A. Disconnect power to the
entire system.
B. Pull the Anchor and
Bearing Assembly and
approximately 18ā€ (45
cm) of auger out of the
boot.
C. Place a clamp or locking
pliers on the auger to
prevent it from spring-
ing back into the auger
tubes.
D. Remove Anchor and Bearing Assembly.
E. Carefully release the clamp securing the auger.
CAUTION: Stand clear...the auger will spring back into
the tubes.
F. Remove the remaining system components in the opposite
order they were installed, according to this manual.
8. Replacing the battery in the Agri-Timer:
A. Disconnect electrical service at the breaker.
B. Remove the (2) screws and the face of the timer.
C Replace the existing batteries with new batteries.
D. Use existing wire ties to secure the new batteries in place.
E. Reinstall the face of the timer and secure using (2) screws
previously removed.
F. Reconnect electrical service to the system.
9. Proximity Switch Adjustment Procedures:
The Proximity Switch includes an adjustable delay. The delay
may be set from 1 second to 10 minutes.
A. Use a small screw driver provided to turn the Delay Adjust-
ment Screw (see figure on page 55). Turn the screw counter
clockwise until the light stays on. Turn the screw clockwise
one complete revolution. This sets the delay to 1 second.
B. To increase the delay, turn the Delay Adjustment Screw
clockwise.
Watch the indicator light; quick flashes = shorter time delay,
slow flashes = longer time delay.
The Proximity Switch is shipped with the sensitivity preset at the
factory. This setting is adequate for most feed types and
conditions. However if the sensitivity does need to be adjusted,
carefully follow these instructions:
A. Allow power to be supplied to the switch for at least 15 min-
utes to properly warm the sensor. Chore-Time recommends
wiring the proximity switch to have a constant 220 V. supply.
See the wiring diagrams supplied with the Proximity Switch.
B. Set the Proximity Switch time delay to 1 second as specified

Other manuals for Chore-Time FLEX-AUGER 108

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chore-Time FLEX-AUGER 108 and is the answer not in the manual?

Chore-Time FLEX-AUGER 108 Specifications

General IconGeneral
BrandChore-Time
ModelFLEX-AUGER 108
CategoryIndustrial Equipment
LanguageEnglish