Christ Alpha 2-4 LSCplus - Packaging; Transport Safety Device

Freeze-dryer Alpha 1-4 LSCplus
Freeze-dryer Alpha 2-4 LSCplus
4 Storage and transport
30 / 131
Version 01/2011, Rev. 2.3 of 03/07/2017 • sb
Translation of the original operating manual

4.4 Packaging
The freeze-dryer is packaged in a cardboard box or in a wooden crate,
depending on the scope of supply.
• After opening the packaging, take out the box containing the
accessories.
• Remove the packaging material.
• Lift the freeze-dryer upwards and out of the crate/cardboard box. When
lifting the unit, always reach under the freeze-dryer from the side.
CAUTION
The freeze-dryer Alpha 1-4 LSCplus weighs approx. 48 kg!
The freeze-dryer Alpha 2-4 LSCplus weighs approx. 60 kg!
• Retain the packaging for any possible future transport of the freeze-
dryer.

4.5 Transport safety device
Prior to start-up, the vacuum sensor must be installed (see chapter 5.5 -
"Vacuum sensor").
NOTE
Prior to any transport, the vacuum sensor must be deinstalled.