Christ Beta 1-8 LSCbasic - Packaging; Transport Safety Devices

Freeze-dryer Beta 1-8 LSCbasic
Freeze-dryer Beta 2-8 LSCbasic
4 Storage and transport
Version 03/2018, Rev. 1.5 of 09/03/2020 • sb-dc
35 / 107
Translation of the original operating manual
→
4.4 Packaging
The freeze-dryer is packaged in a wooden crate.
• After opening the packaging, take out the accessories.
• Remove the packaging material.
• Remove the side walls of the crate.
• Lift the freeze-dryer upwards and out of the crate/cardboard box. When
lifting the unit, always reach under the freeze-dryer from the side.
CAUTION
The freeze-dryer Beta 1-8 LSCbasic weighs approx. 63 kg!
The freeze-dryer Beta 2-8 LSCbasic weighs approx. 78 kg!
CAUTION
The centre of gravity of the freeze-dryer is off-centre!
• Retain the packaging for any possible future transport of the freeze-
dryer.
→
4.5 Transport safety devices
Prior to start-up, the vacuum sensor must be installed (see chapter 5.5 -
"Vacuum sensor").
NOTE
Prior to any transport, the transport safety devices must be deinstalled.