Programmable AC Source 6430/6420/6415 User‘s Manual
6-24
−103 Invalid separator
−104 Data type error
−108 Parameter not allowed [more parameters are received than expected]
−109 Missing parameter [less parameters are received than required]
−110 Command header error
−111 Header separator error
−112 Program mnemonic too long [more than 12 characters]
−113 Undefined header [the header is syntactically correct, but undefined]
−120 Numeric data error
−123 Exponent too large [the exponent magnitude is larger than 32000]
−124 Too many digits [more than 255 digits but excluding leading zeros]
−128 Numeric data not allowed [the received numeric data are not accepted for
the header]
−130 Suffix error
−138 Suffix not allowed
−141 Invalid character data
−144 Character data too long [more than 12 characters]
−148 Character data not allowed
−221 Settings conflict [e.g., enable external program mode while the output voltage
range is AUTO]
−222 Data out of range [e.g., set voltage to 200 Volts while the output voltage range
is 150V]
−230 Data corrupt or stale
−350 Queue overflow [more than 16 errors]
−410 Query INTERRUPTED [a new program message was received before a
response is completely sent]
−420 Query UNTERMINATED [addressed to talk but an incomplete program
message was received]
−430 Query DEADLOCKED [output buffer overflows because of too many queries]
−440 Query UNTERMINATED after an indefinite response [a query was received
in the same program message after an indefinite response]
11 Command used for RS-232C interface only.
To Next Page
Loading...
