4.1.2 THE CONSOLE
The console of the ME1500 has a very simple front control panel with a display and two buttons.
The LCD display (2 rows with 40 characters per row) is used to indicate the operating states of
the machine.
The button is used to switch between normal operating mode and pause status and
to reset any error.
The button is user to retry the last operation after an error.
4.2 STORED CONFIGURATION AND REPLACING LITHIUM BATTERY
The LCD EDIT format and the SETUP configuration parameters (see Annex A and B)
are stored into a memory provided with a lithium backup battery. When the battery level
is down the machine may lose the configuration and the LCD EDIT formats. Before this
critical level is reached, the display will show the alarm “BATT LOW”
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE
ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER.
DISPOSE OF USED BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
ME 1500 – Operators Manual
To Next Page
