DECLARATION OF ‘CE’ CONFORMITY
The manufacturer MF GROUP srl ‐ Via Serra, 2 ‐ 40012 Calderara di Reno ‐ Bologna ‐ Italy,
DECLARES UNDER SOLE RESPONSIBILITY THAT THE METAL PLATE SYSTEMS
Metal Embosser
MODEL
ME1500
TO WHICH THIS DECLARATION REFERS, ARE IN
CONFORMITY WITH THE FOLLOWING EUROPEAN UNION
DIRECTIVES:
of 17 May 2006 on machinery, and amending Directive 95/16/EC
of 12 December 2006 on the harmonization of the laws of Member States
relating to electrical equipment designed for use within certain voltage limits
of 15 December 2004 on the approximation of the laws of the Member States
relating to electromagnetic compatibility and repealing Directive 89/336/EEC
of 8 June 2011 on the restriction of the use of certain hazardous substances in
electrical and electronic equipment (recast), replacing Dir. 2002/95/EC
AND WITH PARTICULAR REFERENCE TO THE FOLLOWING
INTERNATIONAL IEC STANDARDS:
Safety of machinery - General principles for design - Risk assessment and risk reduction
Electrical equipment of machines – safety of machinery
Safety of information technology equipment
Radio disturbance characteristics
Harmonic current emissions
Voltage fluctuations and flicker
Electrostatic discharge immunity
Immunity to Radio frequency electromagnetic fields
Immunity to Fast voltage transients on Power AC line and serial data line
Power frequency magnetic field immunity test
Immunity to conducted disturbances, induced by radio-frequency fields
Immunity to voltage dips, short interruptions and voltage variations
Calderara di Reno, September 1st, 2014
POSITION President
Person authorised to compile the technical file:
Mr Alberto MUCELLI
Via Serra 2 - Calderara di Reno (BO)
Last two digits of the year in which the CE marking was affixed: 14
To Next Page
