WarmAir
Model 135 Manual OPERATING INSTRUCTIONS
Page 11 of 43
Section 2: Specifications
Physical
Dimensions: 8.75"W x 8.75"D x 13.5"H
(22.2 cm x 22.2 cm x 34.3 cm)
Hose Outlet: 6' (1.8m) flexible hose
Weight: 13.5 lbs. (6.1 kg)
Filtration: 0.2 microns, High Efficiency
Construction: Impact-resistant plastic case with aluminum sub-structure. None of the
WarmAir
135 System components contain latex.
Electrical
WarmAir
135 unit is available in 100V, 110-120V or 220-240V:
100V, 50/60 Hz and 110-120V, 50/60Hz units:
1200 VA
15 Amp Circuit Breaker
15' (4.6m) Power Cord (14/3 SJT with Hospital-Grade plug)
220-240V, 50/60Hz units:
1200 VA
7 Amp Circuit Breaker
15’ (4.6m) Harmonized Power Cord (H05VV-F 3x1.5mm² cord
with CEE 7/7 plug)
220-240V, 50/60Hz units:
1200VA
13 Amp Circuit Breaker
15’ (4.6m) British Standard Power Cord (HO5VVF3G1.5mm
molded-on BS1363 fused male plug)
For all units:
Under 300 A earth leakage current
Ground resistance 0.2 or less
Mains Supply Isolation: Two-Pole Mains Switch
Temperature Control System
Control System: Microprocessor and thermistor-based.
Temperature Settings as
measured at the hose
outlet of the device:
No Heat (ambient temperature)
32.2°C +4.0°C/ -2.0°C (90°F +7.2°F/ -3.6°F)
37.8°C +4.0°C/ -2.0°C (100°F +7.2°F/ -3.6°F)
43.3°C +4.0°C/ -2.0°C (110°F +7.2°F/ -3.6°F)
Operating Environment:
Temperature: 15°C to 30°C (59°F to 86°F)
Relative Humidity: 20% - 60%
To Next Page
