The example below shows how to save your settings as “User Default” so that you may
restore user defaults at a later time:
Steps
Action User Feedback if Successful
1 Power on the scanner…
he scanner will respond with a long beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
2 Enter the Configuration Mode…
he scanner will respond with six beeps
(high-low
tone repeats three times), and
its LED indicator will be flashing red.
3 Read a Setup barcode…
For example,
he scanner will respond with two beeps
(low-high tone) if reading a normal setup
barcode.
4 Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
5 The scanner will automatically restart itself… Same as for Power on the scanner.
* When any configuration error occurs...
he scanner will respond with one long
beep (low tone).
To Next Page
Loading...
Need help?
General
