1.11 AUTO-SENSE MODE (1500 ONLY)
This mode is only available when you want to seat the scanner in the Auto-Sense Stand.
When you enable this mode, it will force the scanner to apply Laser mode as the scan
mode. However, it works slightly different from the original Laser mode. Now the scanner
will be expecting barcodes as long as it is seated in the Auto-Sense Stand, as shown
below. Whenever a barcode is brought within range, the scanner will be able to decode it.
Note: Auto-sense can only be enabled for CCD scanner and will force it to Laser mode.
To stop this mode, you may remove the scanner from the stand or have the
scanner read the “Disable (Auto-Sense)” barcode below. It will return to Laser
mode. If Laser mode is not desired, proceed to select a scan mode best suits your
application.
Enable
*Disable
When the ambient light is too dim to activate the sensor, you may have the scanner read
the “High Sensitivity” barcode to improve performance. Starting from firmware version
1.12, it will emit scan beam every 300 milliseconds when “High Sensitivity” is enabled.
High Sensitivity
*Normal
Note: If the ambient light is under 100 lux, we suggest that you either add lighting or
use Continuous mode instead.
To Next Page
Loading...
Need help?
General
