3.8.5. CONVERT UHF EPC TO ASCII
Enable “Convert UHF EPC to ASCII” to work with RK25 UHF RFID Reader to convert the EPC
code (hexadecimal) to ASCII code under the following conditions:
▪ All the decoded EPC code (hexadecimal) corresponds to ASCII code must be visible
characters. If not, the EPC code would not be converted and remaind as hexadecimal
values.
▪ If the last two values are 00, the 00 will be deleted and then the EPC code is converted
to ASCII code, e.g. the decoded EPC code is 3538355959504a5442434900, and it
becomes ASCII mode EPC “585YYPJTBCI” after being converted.
3.8.6. VERSION
The version information about Enterprise Settings is listed right below “Convert UHF EPC to
ASCII”.
To Next Page
Loading...
