Service Manual 15
Raption
1- DC Contactor. 12Vdc. 200A
(KM10.2/KM10.3/KM11.2/KM11.3)
2- Diode rectifier 380A (E9.1)
with forced ventilation (M9.1/
M9.2)
3- Fuse holder (F9.1/ F9.2/
F9.3/F9.4)
F9.2 and F9.4 not included in
Raption 50 HV model
(2)
4- Emergency button (S12.1) 5- Isolation protection device
(B19.1/B19.2)
6- Heater with fan 400W
(M16.5)
7- Ceramic fuse 5x20 1A
(F4.1/F4.2/F4.3)
8- Miniature circuit breaker 3
poles 50A class C (Q6.1/Q6.2/
Q7.1/Q7.2)
Q7.1 and Q7.2 not included in
Raption 50 HV model
(2)
9- Conctactor (K16.3)
10- Three-phase MID energy
meter (P12.1)
11- AC MCB (Q12.1) 12- Auxiliar contact (K12.2)
13- RCD protection (T5.1) 14- RCD protection (T12.1) 15- Panel thermostat NC. 10A
250Vac (B16.1)
16- Contactor 4 Poles (KM13.1) 17- Mode 4 Control Board
(N17.1)
18- 24Vdc Power Supply
(G14.1)
19- Electrolytic capacitor buffer
module (G14.3)
20- Expansion board (N8.1) 21- 12Vdc Power Supply
(G14.2)
22- Fuse terminal (F11.1/F19.1/
F19.2)
23- Relays board (K5.1/K5.2)
K5.2 not included in Raption 50
HV model
(2)
24- Mode 3 (E12.1)
25- RJ45 Adaptor (X12.1)
26- 12Vdc Relays (K12.1, K5.3,
K16.4, K11.1, K19.1, K11.2, K16.2,
K14.1)
27- RCBO 1P+N 10A 30mA
class A (Q14.2, Q14.3)
(2)
Fuse holders included in Raption 50 HV may vary because directly depend on the power
modules installed (see page 16). In case of doubt, contact our Post-Sales Department.
To Next Page
Loading...
