Raption
80 Service Manual
E
Communication errors
When an internal device cannot reach the main controller of the Charging Station, the
Screen, a communications error will be generated.
These types of errors can be generated by many reasons:
• Device improperly powered
• Cables incorrectly fastened or bad contact.
• Problems in the RS485 bus.
• Faulty device.
The setup webpage, allows service staff to identify the component(s) that is not
communicating, so spare part(s) can be prepared in advance for an eventual replace.
Check in the ‘Dashboard’ section, in the ‘Devices status’ tab if all components are ‘Ok’:
To Next Page
Loading...
