8-3
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 8 Configuring ATM Permanent Virtual Circuit Autoprovisioning
ATM PVC Autoprovisioning
VC Class
A VC class is a set of preconfigured VC parameters that you configure and apply to a particular VC or
ATM interface. The VC parameters that you can configure for a VC class include the following:
• Attach ATM VC class to an interface (class-int command)
• Constant bit rate (cbr command)
• Encapsulation type (encapsulation aal5 command)
• Idle-timeout (idle-timeout command)
• Integrated Local Management Interface (ILMI) management (ilmi manage command)
• Inverse ARP broadcasts (protocol command)
• Inverse ARP time period (inarp command)
• OAM management on a PVC (oam-pvc command)
• OAM management parameters for re-establishing and removing a PVC connection (oam retry
command)
• PVC autoprovisioning (create on-demand command)
• Queue depth (queue-depth command)
• Static map for an ATM PVC or VC (protocol command)
• Unspecified bit rate (ubr command)
• Variable Bit Rate-Non Real Time quality of service (vbr-nrt command)
• Weight (weight command)
For more information, see the Configuring ATM chapter in the Cisco IOS Wide-Area Networking
Configuration Guide.
To Next Page
Loading...
