Cisco 10000-2P2-2DC - Configuration Tasks; Configuration Examples

23-10
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 23 Configuring Gigabit EtherChannel Features
Configuring PPPoX Support on a GEC Bundle
Configuration Tasks
To enable PPPoE session creation on a GEC bundle, enter the following commands:
For more information on PPPoE over Ethernet, see the Cisco 10000 Series Router Software
Configuration Guide at:
http://www.cisco.com/en/US/docs/routers/10000/10008/configuration/guides/broadband/vlan.html
Configuration Examples
Example 23-4 shows how to enable a PPPoE session on a GEC bundle:
Example 23-4 Enabling a PPPoE Session
interface Port-channel32
no ip address
no negotiation auto
lacp max-bundle 1
lacp fast-switchover
!
interface Port-channel32.1
encapsulation dot1Q 10
pppoe enable group bba_group_1
!
interface Port-channel32.2
encapsulation dot1Q 20
pppoe enable group bba_group_1
!
Command Purpose
Step 1
router(config)# interface port-channel number
Creates a GEC bundle.
Step 2
router(config)# lacp max-bundle 1-8
Sets the maximum number of active links per
GEC bundle. For PPPoE sessions maximum
number of active links is one.
Step 3
router(config)# lacp fast-switchover
Retains PPPoX sessions incase of member
link switchover.
Step 4
router(config)# interface port-channel
subinterface
Creates a GEC bundle subinterface and
enters the subinterface mode.
Step 5
router(config-subif)# encapsulation dot1Q
vlan-id
Enables IEEE 802.1Q encapsulation of
traffic on a specified subinterface in a
VLAN. Specify the VLAN identifier.
Step 6
router(config-subif)# pppoe enable group global
Enables PPPoE session on the GEC bundle
subinterface.
global is the default group used when a
group name is not specified.
Step 7
router(config-subif)# end
Exits to the global configuration mode.