Cisco 10000-2P2-2DC - Verifying L2 VPN Interworking

21-30
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 21 Configuring L2VPN Interworking
Verifying L2VPN Interworking
config t
mpls label protocol ldp
interface Loopback100
ip address 10.0.0.100 255.255.255.255
pseudowire-class atm-fr
encapsulation mpls
interworking ip
interface atm 2/0/0
pvc 0/200 l2transport
encapsulation aal5
xconnect 10.0.0.200 140 pw-class atm-fr
The following example shows how to configure the FR DLCI to ATM AAL5 feature on a PE2 router:
config t
mpls label protocol ldp
interface Loopback100
ip address 10.0.0.200 255.255.255.255
pseudowire-class atm-fr
encapsulation mpls
interworking ip
frame-relay switching
interface serial 2/0/0:1
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci 567 switched
connect mpls serial 2/0/0:1 567 l2transport
xconnect 10.0.0.100 150 pw-class atm-fr
Verifying L2VPN Interworking
To verify the L2VPN status - local switching, use the following commands:
• show connection [all | name | id | elements | port ]
• show pxf cpu atom [circuits | interface | vcci]
To view the L2VPN statistics - local switching, use the following command:
• show pxf cpu statistics atom
To verify the L2VPN status - AToM, use the following commands:
• show connection [all | name | id | elements | port ]
• show xconnect [ all | interface | peer ]
• show mpls l2transport [binding | checkpoint | hw-capability | summary | vc ]
• show mpls infrastructure lfd pseudowire vcid
• show pxf cpu atom [circuits | interface | vcci]
To verify the L2VPN statistics - AToM, use the following commands:
• show pxf cpu statistics atom
• show pxf cpu subblocks