Cisco 10000-2P2-2DC - Defining RADIUS and Enabling NAS-PORT; Defining a VRF; Applying AAA to a Virtual Template

11-7
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 11 Configuring Local AAA Server, User Database—Domain to VRF
Defining RADIUS and Enabling NAS-PORT
To define RADIUS and enable NAS-PORT, enter the following commands in global configuration mode:
Defining a VRF
To define a VRF, enter the following commands beginning in global configuration mode:
Applying AAA to a Virtual Template
To apply AAA to a virtual template, enter the following commands in global configuration mode:
Step 3
Router(config)# aaa authorization network
list-name local if-authenticated
Specifies to use the local profile if authenticated.
Step 4
Router(config)# aaa accounting network
list-name start-stop group radius
Specifies RADIUS accounting as optional.
Step 5
Router(config)# aaa authentication ppp
default local
Required to allow the definition of the AAA authentication list in
the AAA attribute list.
Step 6
Router(config)# aaa authorization network
default local
Required to allow the definition of the AAA authorization list in
the AAA attribute list.
Command Purpose
Command Purpose
Step 1
Router(config)# radius-server host
ip-address auth-port 1645 acct-port 1646
key password
Defines the Radius server that AAA authentication, authorization
and accounting requests are sent to.
Step 2
Router(config)# radius-server attribute
nas-port format d
Defines NAS-Port information to be sent to the AAA accounting
server. (optional)
Command Purpose
Step 1
Router(config)# ip vrf vrf-name
Enters VRF configuration mode and defines the VRF instance by
assigning a VRF name.
Step 2
Router(config-vrf)# rd
route-distinguisher
Creates routing and forwarding tables.
Step 3
Router(config-vrf)# route-target {import
| export | both}
route-target-ext-community
Creates a list of import an export route target communities for the
specified VRF.
Command Purpose
Step 1
Router(config)# interface
virtual-template number
Defines the virtual template to use for PPP.
Step 2
Router(config)# ppp mtu adaptive
For PPPoE, defines auto negotiation of MTU size.
Step 3
Router(config)# ppp authentication pap
chap
Enables PAP, then CHAP, for PPP authentication.