Cisco 10000-2P2-2DC - Moving a Member Link to a Different MLP Bundle

22-35
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Configuring MLP Bundles and Member Links
Router(config-if)# ip address 10.6.6.1 255.255.255.0
Router(config-if)# ppp multilink
Router(config-if)# ppp multilink group 1
!
Router(config)# interface virtual-template1
Router(config-if)# ppp max-configure 110
Router(config-if)# ppp max-failure 100
Router(config-if)# ppp timeout retry 5
Router(config-if)# keepalive 30
Router(config-if)# no ip address
Router(config-if)# ppp multilink
!
Router(config)# interface atm 6/0/0
Router(config-if)# no ip address
Router(config-if)# hold-queue 4096 in
!
Router(config)# interface atm 6/0/0.1 point-to-point
Router(config-if)# no ip address
Router(config-if)# pvc 0/34
Router(config-if-atm-vc)# vbr-nrt 512 256 20
Router(config-if-atm-vc)# encapsulation aal5snap
Router(config-if-atm-vc)# protocol ppp Virtual-Template 1
Router(config-if-atm-vc)# ppp multilink group 1
!
Router(config)# interface atm 6/0/0.2 point-to-point
Router(config-if)# no ip address
Router(config-if)# pvc 0/35
Router(config-if-atm-vc)# vbr-nrt 512 256 20
Router(config-if-atm-vc)# encapsulation aal5snap
Router(config-if-atm-vc)# protocol ppp Virtual-Template 1
Router(config-if-atm-vc)# ppp multilink group 1
!
Router(config)# interface ATM 6/0/0.3 point-to-point
Router(config-if)# no ip address
Router(config-if)# pvc 0/36
Router(config-if-atm-vc)# vbr-nrt 512 256 20
Router(config-if-atm-vc)# encapsulation aal5snap
Router(config-if-atm-vc)# protocol ppp Virtual-Template 1
Router(config-if-atm-vc)# ppp multilink group 1
Moving a Member Link to a Different MLP Bundle
To move a member link to a different MLP bundle, enter the following commands beginning in interface
configuration mode: