Cisco 10000-2P2-2DC - Configuration Example for Mlpoe LAC Switching; Configuration Examples of Mlpoe at PTA

22-41
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Configuration Examples for Configuring MLP
Configuration Example for MLPoE LAC Switching
Example 22-9 shows how to configure the LAC for switching an MLPoE connection to the LNS, while
also forwarding the DSL tags.
Example 22-9 MLPoE LAC Switching
aaa new-model
!
multilink bundle-name authenticated
vpdn enable
!
vpdn-group LACoe_LFI
request-dialin
protocol l2tp
domain hello_oe
dsl-line-info-forwarding
initiate-to ip 192.168.125.54
local name LACoe_LFI
l2tp tunnel password 0 lab
!
username LNSoe_LFI nopassword
!
bba-group pppoe global
virtual-template 800
vendor-tag dsl-sync-rate service
!
interface GigabitEthernet4/0/0
no ip address
negotiation auto
!
interface GigabitEthernet4/0/0.1
encapsulation dot1Q 800
pppoe enable group global
!
interface GigabitEthernet4/1/0
ip address 192.168.125.53 255.255.255.0
negotiation auto
!
interface Virtual-Template800
no peer default ip address
keepalive 30
ppp authentication pap
ppp multilink
ppp multilink links maximum 1
!
Configuration Examples of MLPoE at PTA
This section has the following configuration examples of the MLPoE at PTA feature:
• Configuring MLPoE over IEEE 802.1Q VLANs
• Configuring MLPoE through RADIUS