Cisco 10000-2P2-2DC - Optional Configuration Tasks for On-Demand Address Pool Manager; Defining Odaps on an Interface; Configuring Odaps to Obtain Subnets through IPCP Negotiation

10-10
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 10 Configuring Address Pools
On-Demand Address Pool Manager
!
interface Virtual-Template1
ip vrf forwarding Green
no ip address
!
ip radius source-interface Ethernet1/1
!
!IP address of the Radius server host
radius-server host 172.16.1.1 auth-port 1645 acct-port 1646
radius-server retransmit 3
radius-server attribute 32 include-in-access-req
radius-server attribute 44 include-in-access-req
radius-server key cisco
radius-server vsa send accounting
radius-server vsa send authentication
Optional Configuration Tasks for On-Demand Address Pool Manager
To configure the on-demand address pool manager feature, perform any of the following optional
configuration tasks:
• Defining ODAPs on an Interface, page 10-10
• Configuring ODAPs to Obtain Subnets Through IPCP Negotiation, page 10-11
• Disabling ODAPs, page 10-11
Defining ODAPs on an Interface
To configure the on-demand address pool manager feature on an interface, enter the following
commands beginning in global configuration mode:
Note When you configure the on-demand address pool mechanism on an interface-by-interface basis, the
ODAP overrides the global default address pool mechanism configured on the interface.
Command Purpose
Step 1
Router(config)# interface name
Specifies the interface and enters interface configuration mode.
Step 2
Router(config-if)# peer default ip
address dhcp-pool
Specifies to return an IP address from an on-demand address pool
to a remote peer connecting to the interface. This command
supports only remote access (PPP) sessions into MPLS VPNs.