Cisco 10000-2P2-2DC - Page 4

Contents
iv
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Multiple Ingress and Multiple Egress Provider Edge Applications 1-15
New Features, Enhancements, and Changes 1-15
New Features in Cisco IOS Release 12.2(33)XNE3 1-16
New Features in Cisco IOS Release 12.2(33)XNE 1-16
New Features in Cisco IOS Release 12.2(33)SB3 1-18
New Features in Cisco IOS Release 12.2(33)SB2 1-18
New Features in Cisco IOS Release 12.2(33)SB 1-18
New Features in Cisco IOS Release 12.2(31)SB5 1-19
New Features in Cisco IOS Release 12.2(31)SB3 1-19
New Features in Cisco IOS Release 12.2(31)SB2 1-20
New Features in Cisco IOS Release 12.2(28)SB1 1-21
New Features in Cisco IOS Release 12.2(28)SB 1-21
New Features in Cisco IOS Release 12.3(7)XI7 1-25
New Features in Cisco IOS Release 12.3(7)XI3 1-26
New Features in Cisco IOS Release 12.3(7)XI2 1-26
New Features in Cisco IOS Release 12.3(7)XI1 1-26
CHAPTER 2 Scalability and Performance 2-1
Line Card VC Limitations 2-1
Limitations and Restrictions 2-3
Scaling Enhancements in Cisco IOS Release 12.2(33)XNE 2-4
Scaling Enhancements in Cisco IOS Release 12.2(33)SB 2-5
Layer 4 Redirect Scaling 2-5
Scaling Enhancements in Cisco IOS Release 12.3(7)XI1 2-6
FIB Scaling 2-6
Policy-Map Scaling 2-6
Queue Scaling 2-7
Scaling Enhancements in Cisco IOS Release 12.3(7)XI2 2-7
Queue Scaling 2-7
VC Scaling 2-8
Scaling Enhancements in Cisco IOS Release 12.2(28)SB 2-8
Configuring the Cisco 10000 Series Router for High Scalability 2-8
Configuring Parameters for RADIUS Authentication 2-9
Configuring L2TP Tunnel Settings 2-9
VPDN Group Session Limiting 2-10
Configuring the PPP Authentication Timeout 2-10
Disabling Cisco Discovery Protocol 2-10
Disabling Gratuitous ARP Requests 2-11
Configuring a Virtual Template Without Interface-Specific Commands 2-11