20-17
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 20 Configuring L2 Virtual Private Networks
Configuration Tasks for L2VPN
Example 20-6 shows how to enable OAM cell emulation on an ATM PVC.
Example 20-6 OAM Cell Emulation on an ATM PVC
interface ATM 1/0/0
pvc 1/200 l2transport
encapsulation aal5
xconnect 13.13.13.13 100 encapsulation mpls
oam-ac emulation-enable
oam-pvc manage
Example 20-7 shows how to set the rate at which an AIS cell is sent to every 30 seconds.
Example 20-7 Setting the AIS Send Rate in OAM Cell Emulation on an ATM PVC
interface ATM 1/0/0
pvc 1/200 l2transport
encapsulation aal5
xconnect 13.13.13.13 100 encapsulation mpls
oam-ac emulation-enable 30
oam-pvc manage
Verifying OAM Cell Emulation on an ATM PVC
In Example 20-8, the show atm pvc command shows that OAM cell emulation is enabled on the
ATM PVC.
Example 20-8 show atm pvc Command Output
Router# show atm pvc 5/500
ATM4/1/0.200: VCD: 6, VPI: 5, VCI: 500
UBR, PeakRate: 1
AAL5-LLC/SNAP, etype:0x0, Flags: 0x34000C20, VCmode: 0x0
OAM Cell Emulation: enabled, F5 End2end AIS Xmit frequency: 1 second(s)
OAM frequency: 0 second(s), OAM retry frequency: 1 second(s)
OAM up retry count: 3, OAM down retry count: 5
OAM Loopback status: OAM Disabled
OAM VC state: Not ManagedVerified
ILMI VC state: Not Managed
InPkts: 564, OutPkts: 560, InBytes: 19792, OutBytes: 19680
InPRoc: 0, OutPRoc: 0
InFast: 4, OutFast: 0, InAS: 560, OutAS: 560
InPktDrops: 0, OutPktDrops: 0
CrcErrors: 0, SarTimeOuts: 0, OverSizedSDUs: 0
Out CLP=1 Pkts: 0
OAM cells received: 26
F5 InEndloop: 0, F5 InSegloop: 0, F5 InAIS: 0, F5 InRDI: 26
OAM cells sent: 77
F5 OutEndloop: 0, F5 OutSegloop: 0, F5 OutAIS: 77, F5 OutRDI: 0
OAM cell drops: 0
Status: UP
To Next Page
Loading...
