Cisco 10000-2P2-2DC - Page 607

Index
IN-11
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
G
GE, Gigabit Ethernet 1-4
GEC
802.1Q and QinQ
configuration examples 23-8
configuration tasks 23-8
prerequisites 23-7
restrictions 23-7
active link 23-1
bundle 23-1
deployment
access 23-1
core 23-1
HA
ISSU 23-11
NSF 23-11
NSR 23-11
SSO 23-11
high availability 23-11
maximum links 23-1
member links 23-11
configuration tasks 23-11
multicast VPN 23-9
multicast VPN configuration tasks 23-9
passive links 23-1
policy based routing on bundle 23-7
port channel 23-1
PPPoX 23-9
configuration examples 23-10, 23-14
configuration tasks 23-10
restrictions 23-9
prerequisites 23-3
QoS
configuration examples 23-5 to 23-6, ?? to 23-15
deployment mode 23-4
input QoS 23-3, 23-4, 23-5
input QoS for subinterface 23-4
on bundle subinterfaces 23-6, 23-15
on member links 23-5, 23-16
on VLAN groups 23-5
output QoS 23-4
output QoS for subinterface 23-4
restrictions 23-5
service policies 23-3 to 23-4
restrictions 23-3
GEC, Gigabit EtherChannel 23-1
Generic Route Encapsulation, definition 1-4
Gigabit Ethernet, definition 1-4
GRE 1-4
GRE tunnel IP source and destination VRF membership
feature overview 27-1
restrictions 27-3
group session-limit command 4-17, 4-18
guide revision history i-xxv
H
half-duplex VRF 1-27
feature overview 4-21
prerequisites 4-23
restrictions 4-23
show commands 4-29
HDLC/PPP 20-10
connect command 20-10
encapsulation hdlc 20-11
HDLC Like-to-Like Local Switching 20-11
Interworking 20-10
Maximum Transmission Unit (MTU) 20-11
PPP Like-to-Like Local Switching 20-10
Prerequisites 20-10
PWRED. 20-10
Restrictions 20-10
HDLC over MPLS 20-36
HDVRF, See half-duplex VRF
head-of-the-line blocking of IP input process 2-19
HGW, definition 1-4
hierarchical input policing 1-22