Cisco 10000-2P2-2DC - Page 609

Index
IN-13
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
ip multicast-routing command 15-35
IP overlapping address pools, example 10-18
IP over Q-in-Q 1-25
ip pim dense-mode command 15-35
ip pim sparse-dense-mode command 15-36
ip pim sparse-mode command 15-36
ip radius source-interface command 5-34
IP receive ACLs 1-27
configuration example 12-3
configuring 12-2
feature overview 12-1
restrictions 12-2
show commands 12-3
IP SLAs-LSP health monitor 1-23
ip tos reflect command 9-6
ip unnumbered loopback command 5-29
IP unnumbered on 802.1Q VLANs 1-27
benefits 7-2
configuration example 7-4
configuring 7-3
overview 7-1
restrictions 7-3
show commands 7-5
ip-unnumbered RADIUS attribute 2-17, 3-5
IPv6 1-23, 24-1
IPv6 Internet Access 4-11
All Internet Routes in VRF 4-12
Non-VRF Internet Access 4-11
Using Static Routes in VRF 4-12
VRF interface 4-12
IPv6 VPN over MPLS (6VPE) 4-7
Configuration tasks 4-9
Monitoring and maintaining 4-15
Prerequisites 4-8
Restrictions 4-9
the ipv6 unicast-routing command 4-8
IPv6 VRF's 4-9
ip vrf command 4-24, 5-36
ip vrf forwarding command 5-32, 5-34, 27-2
IRB 1-5
ISA 1-22
ISO 1-5
ISP 1-5
ISSU 1-22
ITU-T 1-5
K
K1 and K2 bytes 14-20
keepalive command 2-17
keys
specifying authentication and encryption key 5-32,
5-37
L
L2F 1-5
L2TP
access concentrator 5-2, 5-7, 5-8, 5-11, 1-5
congestion avoidance 1-23
definition 1-5
displaying errors and events 5-35, 5-52
domain screening 1-25
tunnel settings 2-9
l2tp ip tos reflect command 9-1
L2VPN 20-1
/32 mask 20-5
AToM 20-1
Checkpointing AToM Information 20-7
control word 20-2
debug acircuit checkpoint command 20-7
debug mpls l2transport checkpoint command 20-7
label-switched paths (LSPs) 20-4
LDP 20-2
LS 20-1
maximum transmission unit (MTU) 20-5
mpls ip command 20-4
MPLS network 20-2