FINAL DRAFT - CISCO CONFIDENTIAL
9-7
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 9 TL1 Commands
Summary of Security Permissions for TL1 Commands
REPT ALM DWDM Message that reports optical alarm
activation/clearing.
See REPT ALM DWDM, page 9-25.
Yes Yes Yes
REPT ALM ENV Message that reports power-bus alarm
activation/clearing.
See REPT ALM ENV, page 9-27.
Yes Yes Yes
REPT ALM EQPT Message that reports general alarm
activation/clearing.
See REPT ALM EQPT, page 9-28.
Yes Yes Yes
REPT EVT DWDM
REPT EVT ENV
REPT EVT EQPT
Message that reports event logging.
See REPT EVT DWDM / REPT EVT
ENV / REPT EVT EQPT, page 9-30.
Yes Yes Yes
REPT EVT FXFR Message that reports FTP file transfer.
See REPT EVT FXFR, page 9-32.
Yes Yes Yes
RTRV-ALM-ALL Retrieves all current alarms.
See RTRV-ALM-ALL, page 9-33.
Yes Yes Yes
RTRV-ALM-DWDM Retrieves current optical alarms.
See RTRV-ALM-DWDM, page 9-35.
Yes Yes Yes
RTRV-ALM-ENV Retrieves current power-bus alarms.
See RTRV-ALM-ENV, page 9-37.
Yes Yes Yes
RTRV-ALM-EQPT Retrieves current general alarms.
See RTRV-ALM-EQPT, page 9-38.
Yes Yes Yes
RTRV-AO Retrieves most-recent autonomous
output (REPT) messages.
See RTRV-AO, page 9-40.
Yes Yes Yes
RTRV-COND-ALL Retrieves condition (state) of all
current alarms.
See RTRV-COND-ALL, page 9-41.
Yes Yes Yes
RTRV-COND-DWDM Retrieves condition (state) of current
optical alarms.
See RTRV-COND-DWDM, page 9-43.
Yes Yes Yes
RTRV-COND-ENV Retrieves condition (state) of current
power-bus alarms.
See RTRV-COND-ENV, page 9-44.
Yes Yes Yes
RTRV-COND-EQPT Retrieves condition (state) of current
general alarms.
See RTRV-COND-EQPT, page 9-46.
Yes Yes Yes
RTRV-DFLT-SECU Retrieves timeouts for access levels.
See RTRV-DFLT-SECU, page 9-47.
No No Yes
RTRV-DWDM Retrieves optical parameters.
See RTRV-DWDM, page 9-48.
Yes Yes Yes
Table 9-8 TL1 Commands and Messages Security Permissions (Access Levels) (continued)
Command or Message Description
User Access Levels
RRWRWA
To Next Page
Loading...
Need help?
General
