2-6
Cisco ME 2400 Ethernet Access Switch Hardware Installation Guide
OL-7678-01
Chapter 2 Switch Installation
Preparing for Installation
• Airflow around the switch and through the vents is unrestricted.
• Temperature around the unit does not exceed 113°F (50°C).
Note If the switch is installed in a closed or multirack assembly, the temperature around it might be
greater than normal room temperature.
Verifying Package Contents
Note Carefully remove the contents from the shipping container, and check each item for damage. If any item
is missing or damaged, contact your Cisco representative or reseller for support. Return all packing
material to the shipping container, and save it.
The switch is shipped with these items:
• Cisco ME 3400 and Cisco ME 2400 Ethernet Access Switches Getting Started Guide
• Regulatory Compliance and Safety Information for the Cisco ME 3400 and Cisco ME 2400 Ethernet
Access Switches
• Product registration card
• AC power cord (ships with AC-powered switches only)
• AC power cord bail (ships with AC-powered switches only)
• DC terminal block (ships with DC-powered switches only)
• Mounting kit containing:
–
Two 19-inch rack-mounting brackets (also used for wall-mounting)
–
Six Phillips flat-head screws for attaching the brackets to the switch
–
Four Phillips machine screws for attaching the brackets to a rack
–
One cable guide and one black Phillips machine screw for attaching the cable guide to one of
the mounting brackets
–
Four Phillips truss-head screws (for wall-mounting brackets)
Optional items include:
• Console cable
• ESTI rack-mounting brackets (RCKMNT-ETSI-1RU)
• 23-inch rack-mounting brackets (RCKMNT-23IN-1RU)
To Next Page
Loading...
Need help?
General
