6-3
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
OL-32185-02
Chapter 6      Install and Upgrade Internal Modules and FRUs
  Safety Warnings
Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings, 
necklaces, and watches). Metal objects will heat up when connected to power and ground and can 
cause serious burns or weld the metal object to the terminals. 
Statement 43
Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or 
laundry tub, in a wet basement, or near a swimming pool. 
Statement 1035
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for wet 
locations. 
Statement 1036 
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been 
disconnected at the network interface. 
Statement 1037 
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a 
remote risk of electric shock from lightning. 
Statement 1038 
Warning
To report a gas leak, do not use a telephone in the vicinity of the leak. 
Statement 1039 
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only 
with the same or equivalent type recommended by the manufacturer. Dispose of used batteries 
according to the manufacturer's instructions. 
Statement 1015 
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to 
hazardous voltages and currents inside the chassis; they contain electromagnetic interference 
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the 
chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are 
in place. 
Statement 1029
Warning
For connections outside the building where the equipment is installed, the following ports must 
be connected through an approved network termination unit with integral circuit protection.
T1 SFP 
Statement 1044