SPA 500 Series IP Phone Advanced User Guide 17 | Page
Monitoring Another Phone from Your Phone
Ivey can configure your phone so that you can monitor other user’s phones with the use
of the Cisco SPA 500s Module. If this feature is required you must add the SPA 500s Expansion
Module. Line buttons on the SPA 500s Expansion module can be used to display the status of
another user’s phone for example, if one of your SPA 500s buttons is configured to display Bob’s
phone line, the LED color will show you the status of his phone line:
• Green: Line is idle.
• Red (steady): Line is active or in use.
• Red (blinking): Line is ringing.
• Orange (solid): Line is unregistered (cannot be used).
• Orange (blinking): Line is not configured properly.
Customizing Your LCD Screen
You can customize your LCD screen in several ways.
Changing the LCD Screen Contrast
To adjust the contrast of the LCD screen:
STEP 1. Press the Setup button, scroll to highlight LCD Contrast, and press the select
button.
STEP 2. Use the navigation button to adjust the screen contrast. Pressing the Left
navigation button decreases the contrast. Pressing the Right navigation
button increases the contrast.
STEP 3. Press save.
Configuring the Phone Screen Saver
You can enable your phone’s screen saver and specify its appearance and the amount of time for
the phone to be idle before it begins.
To configure your screen saver:
STEP 1. Press the Setup button.
STEP 2. Select Screen Saver Modes.
To enable your screen saver:
STEP 1. In Screen Saver Mode, Choose Enable Screen Saver and press edit.
STEP 2. Press y/n to choose yes.
STEP 3. Press ok.
STEP 4. Press save.
To Next Page
Loading...
Need help?
General
