Cisco 6000 series Site Planning Guide

1-6
Cisco Network Convergence System 6000 Series Routers Site Planning Guide
OL-29236-02
Chapter 1 Cisco NCS 6008 Chassis
Chassis Slot Numbers
Figure 1-4 shows the slot numbers on the rear (RP and FC) side of the chassis.
Figure 1-4 Cisco NCS 6008 Chassis Slot Numbers—Rear Side
As shown, the rear (RP and FC) side of the chassis has the following card slots:
• Two RP card slots (RP0 on the far left of the chassis and RP1 on the far right)
• Six FC slots (left to right: 0, 1, 2, 3, 4, 5)
The FC slots can be populated with the following FC type:
• Six FC slots (left to right: 0, 1, 2, 3, 4, 5). The FC slots can be populated with FCs for standalone
chassis operation. See the “Component Product IDs” section on page B-1.
303753
RP and FC cards
Slot 0 Slot 1 Slot 2 Slot 3 Slot 4 Slot 5 Slot 6 Slot 7
RP0 FC0 FC1 FC2 FC3 FC4 FC5 RP1

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS